Bale Wire Coiler Features

  • ASTM A-36 steel construction.  Coating includes sandblast surface preparation, zinc primer, and one coat of gray machinery enamel (guards and hopper OSHA yellow).
     

  • Abrasion resistant steel pressure and rotating plates and replaceable door wear plate of Hardox 500 alloy steel
     

  • C-1045 steel coiling shaft with barbed helix mounted in Rexnord Pillow Block mounted spherical roller bearings
     

  • Low speed non-lubricated roller chain drive with 2.0 service factor
     

  • Heavy duty steel jackshaft housing with Rexnord flange mounted spherical roller bearings to protect drive
    reducer
     

  • Falk or Browning concentric reducer drive with service factor exceeding 2.0
     

  • 7-1/2 HP C-face mounted, TEFC, 460 VAC, 3 phase motor*
     

  • Firestone Airstroke pressure plate actuator with Norgren filter regulator and solenoid valve.  Air consumption is low, as air is used only to pressurize the Airstroke after each coiling cycle.
     

  • Fabricated steel loading Hopper that acts as a guard to prevent access to the coiling compartment
     

  • NEMA 4 control panel for 460 VAC, 3 phase power* with main disconnect, motor circuit protector and reversing motor controller, 115 VAC single phase control transformer, pushbutton controls, indicating lights and cycle timer controls and control circuitry for remote starting for automatic operation
     

  • Safety features include door interlock limit switch, Hopper weight switch to prevent operation with a man’s weight on the Hopper, and complete drive guarding.  Limit switches are Allen Bradley.
     

  • Unit is completely assembled and shop tested and ready to operate upon connection. Operating decals and instructions are near the equipment.
     

  • Includes Instruction and Maintenance manual.

        * 575 VAC 3 phase also available