Bale Wire Coiler Features
ASTM A-36 steel construction.
Coating includes sandblast surface preparation, zinc primer, and one coat of
gray machinery enamel (guards and hopper OSHA yellow).
Abrasion resistant steel pressure
and rotating plates and replaceable door wear plate of Hardox 500 alloy
steel
C-1045
steel coiling shaft with barbed helix mounted in Rexnord Pillow Block
mounted spherical roller bearings
Low
speed non-lubricated roller chain drive with 2.0 service factor
Heavy duty steel
jackshaft housing with Rexnord flange mounted spherical roller bearings to
protect drive
reducer
Falk or
Browning concentric reducer drive with service factor exceeding 2.0
7-1/2
HP C-face mounted, TEFC, 460 VAC, 3 phase motor*
Firestone
Airstroke pressure plate actuator with Norgren filter regulator and solenoid
valve. Air consumption is low, as air is used only to pressurize the
Airstroke after each coiling cycle.
Fabricated steel loading Hopper
that acts as a guard to prevent access to the coiling compartment
NEMA 4 control panel for 460 VAC,
3 phase power* with main disconnect, motor circuit protector and reversing
motor controller, 115 VAC single phase control transformer, pushbutton
controls, indicating lights and cycle timer controls and control circuitry
for remote starting for automatic operation
Safety features include door
interlock limit switch, Hopper weight switch to prevent operation with a
man’s weight on the Hopper, and complete drive guarding. Limit switches are
Allen Bradley.
Unit is completely assembled and
shop tested and ready to operate upon connection. Operating decals and
instructions are near the equipment.
Includes Instruction and Maintenance manual.
* 575 VAC 3 phase also available